The computer can now be wakened via the saved TeamViewer ID.Wake up is to be sent and then click the Add… button. In the TeamViewer ID field, enter the TeamViewer ID in your network via which the signal to.Click the TeamViewer IDs within your network option button.Under Network settings | Wake-on-LAN, click the Configure… button.The TeamViewer options dialog box will open. Click Extras | Options in the main menu.The computer is in one of the following power states.The computer is connected to the Internet via a network cable.The computer has an Internet connection.The computer's network card supports Wake-on-LAN.The computer is connected to a power source.See the manual on how to do it here Tutorial Essentials If the computer logs in automatically and if Teamviewer is added to the AutoStartup list, then it should work like you would like. You can see PC 1 will start up after you click it.You could use 'Wake On Lan' to wake up your computer over the Internet. Then fill in the information like below and click Wake Up. Run Wake On Lan GUI software on a PC from WAN side. Now we check the WAN IP address of the Router PC 1 connected. We need to open a port for PC 1 use Virtual Server. You can fill a random number from 1-65535.Then click Wake Up and you can see PC 1 will start up.Ĥ. Port number is unnecessary if we wake up on Local Subnet. Run Wake On Lan GUI software on another PC in the same LAN. Set Address reservation for PC 1 on our router.Ĥ. Set IP&MAC binding of PC 1 on our router.ģ. Check MAC address and IP address of the computer need Wake-on-LAN. Then Enable ShutDown Wake Up and set Wake Up Capabilities to Magic Packets.Īfter the settings are done on the computer, we need to do some setting on our Router.ġ. Turn on the computer and go to Control Panel- Network and Internet- Network and Sharing Center- Local area connection- Properties- Configure- Advanced. Usually this option is in power management menu.Ģ. Then enable ‘Resume by PCI Device’ and ‘Resume by PCI-E Device’. Here we take WakeOnLanGui as an example.ġ. Wake On Lan Gui, Lan Helper, Magic Packet Utility, NetWaker for Windows. The mainboard and wired network adapter must support Wake-on-LAN feature. It is also possible to initiate the message from another network by using subnet directed broadcasts or a WOL gateway service. The message is usually sent by a program executed on another computer on the same local area network. Wake-on-LAN (WoL) is an Ethernet or Token ring computer networking standard that allows a computer to be turned on or awakened by a network message.

Configuring teamviewer wake on lan